next up previous contents
Next: 10.3 What kind of Up: 10 The most important Previous: 10.1 Number of bands

10.2 High quality quantitative versus qualitative calculations

Before going into further details, we want to distinguish between ``high quality quantitative'' (PREC should be high) and ``qualitative'' calculations (PREC can be medium or even low).

A ``high quality'' calculation is necessary if very small energy-differences (<10 meV) between two competing ``phases'', which can not be described with the same supercell, have to be calculated.

The term ``same supercell'' corresponds here to cells containing the same number of atoms and no dramatic changes in the cell-geometry (i.e. lattice vectors should be almost the same for both cells). For the calculation of energy-differences between two competing bulk-phases it is in many cases impossible to find a supercell, which meets this criterion. If one wants to calculate small energy-differences it is necessary to converge with respect to all parameters (k-points, FFT-meshes, and sometimes energy cut-off). In most cases these three parameters are independent, so that convergence can be checked independently.

For surfaces, things are quite complicated. The calculation of the surface energy is clearly a ``high quality quantitative'' calculation. In this case you have to subtract from the energy of the slab the energy of the bulk phase. Both energies must be calculated with high accuracy. If the slab contains 20 atoms, an error of 5 meV per bulk atom will result in an error of 100 meV per surface atom. The situation is not as bad if one is interested in the adsorption energy of molecules. In this case accurate results (with errors of a few meV) can be obtained with PREC=med, if the reference energy of the slab, and the reference energy of the adsorbate are calculated in the same supercell as that one used to describe adsorbate and slab together.

Ab initio molecular dynamics clearly do not fall into the high quality category because the cell shape and the number of atoms remains constant during the calculation, and most ab initio MD's can be done with PREC=Low. We will give some exception to this general rule when the influence of the k-point mesh is discussed.


next up previous contents
Next: 10.3 What kind of Up: 10 The most important Previous: 10.1 Number of bands

MASTER USER VASP
Mon Mar 29 10:38:29 MEST 1999